Report

[Laser cut and engrave] Holz-Schlüsselanhänger mit Kalifornien-Karte und Home-Schriftzug — Project made with xTool M1 Ultra machine for Laser cut and engrave.

Wooden Keychain with California Map and Home Lettering

Instruction

This project is empowered by AImake

California - Home is where the Heart is

.xs

Application scenario

Laser processing

Machine & module

xTool M1 Ultra

Compatible xTool Machine

F2 Ultra UV

15W

80W

F2 Ultra

40W

F1 Ultra

20W

5W, 10W

5W, 10W, 20W

D1 Pro

5W, 10W, 20W, 40W

55W

10W

10W, 20W, 40W

M1 Ultra

10W, 20W

P2S

55W

Material used

Wooden Keychain

140

Source Image Generated with AImake

Tap to View Prompt and Remix It!

view prompt

Information

      I realize I could pack more, but I wanted to leave it clean and legible so that everything fits on a small keychain. The idea was simply a portable reminder of the years when I was allowed to call California my home.

Instruction

Step1

Preview

I created my image with AI.

Then I marked the area where I wanted to engrave the image.

Once I had set the area, I adjusted the image to the size of my keychain (marked area).

When I was satisfied with everything, I did the framing to be on the safe side. THEN I switched to lasering.

The settings I used were the pre-programmed settings for wooden keychains. But since I wanted it to be a little darker, I did a second run. Of course, this is a matter of taste.

The laser took 00:02:32 minutes with one pass and was therefore done quickly.

I myself am satisfied because I am still at the beginning of my laser journey and hope you like it.

Comments