Report

[Laser cut and engrave] Bananen Anstecknadel aus Holz — Project made with xTool F2 machine for Laser cut and engrave.

[Laser cut and engrave] Bananen Anstecknadel aus Holz — Project made with xTool F2 machine for Laser cut and engrave.

[Laser cut and engrave] Bananen Anstecknadel aus Holz — Project made with xTool F2 machine for Laser cut and engrave.

[Laser cut and engrave] Bananen Anstecknadel aus Holz

[Laser cut and engrave] Bananen Anstecknadel aus Holz

[Laser cut and engrave] Bananen Anstecknadel aus Holz

[Laser cut and engrave] Bananen Anstecknadel aus Holz

[Laser cut and engrave] Bananen Anstecknadel aus Holz

Banana pin made of wood

Instruction

BANANE.xs

BANANE

.xs

Application scenario

Laser processing (2min)

Machine & module

xTool F2

5W, 15W

Compatible xTool Machine

M2

10W, 20W

F2 Ultra UV

5W

P3

80W

F2 Ultra

40W

F1 Ultra

20W

M1

5W, 10W

D1

5W, 10W, 20W

D1 Pro

5W, 10W, 20W, 40W

P2

55W

F1

10W

S1

10W, 20W, 40W

M1 Ultra

10W, 20W

P2S

55W

Material used

1/8"(3mm) Basswood Plywood

gift

3

216

Information

      The banana was first illustrated in ProCreate on an AppleIpad by me and then lasered and cut out of 2 mm thick lime plywood with the F2. For this purpose, the wood was placed on a honeycomb cutting surface (honeycomb) so that it is well ventilated during cutting and as few traces of smoke as possible are created.

Cutting: 90/6Engraving: 70/25

Then I sanded them lightly and colored them with gouache paints and colored pencils. Spray paint was used for sealing. For a subtle, shiny finish on the image itself, I also applied some ClayGlaze.

Finally, a blank pin was attached to the back with gel superglue - and the banana pin is ready. :)

Have fun with it!

Instruction

1

Step1

Banana pin made of wood instruction: step 1 -

Preview

The banana was first illustrated in ProCreate on an AppleIpad by me and then lasered and cut out of 2 mm thick lime plywood with the F2. For this purpose, the wood was placed on a honeycomb cutting surface (honeycomb) so that it is well ventilated during cutting and as few traces of smoke as possible are created.

Cutting: 90/6Engraving: 70/25

Then I sanded them lightly and colored them with gouache paints and colored pencils. Spray paint was used for sealing. For a subtle, shiny finish on the image itself, I also applied some ClayGlaze.

Finally, a blank pin was attached to the back with gel superglue – and the banana pin is ready. :)

Have fun with it!

Comments

Remixes

License

You may also like