Santa Belt Door Hanger

Instruction

SantaBeltHanger

.xcs

Application scenario

Laser processing (45min)

Machine & module

xTool M1 Ultra

20W

Compatible xTool Machine

New

10W, 20W

F2 Ultra UV

15W

80W

F2 Ultra

40W

F1 Ultra

20W

5W, 10W

5W, 10W, 20W

D1 Pro

5W, 10W, 20W, 40W

55W

10W

10W, 20W, 40W

M1 Ultra

10W

P2S

55W

Material used

1/8"(3mm) Basswood Plywood

1110

Information

      Show off your holiday spirit with this simple Santa's belt door hanger

Preview

3 More images

Photo 1
- Start with a 11.5" diameter
- add two smaller circles at the top for hanging
- Add a rectangle and align center wit the diameter
  - this can be done by selection both objects
Photo 2
- Select the larger diameter and paste off to the side.
Photo 3
- Select the rectangle and the large diameter on one of your copies and “unite at overlap”
Photo 4
- You should have four objects now
  - a larger diameter
  - a rectangle with curved edges
  - two smaller circles
Photo 5
- Move the larger diameter to the rectangle
  - select both objects and align center
- Add a square that the same width at the rectangle
- Create an inner outline of that square like shown
- select the squares, rectangle and larger diameter and align center
Photo 6
- Select the belt pieces only and make a copy off to the side
- With those objects still selected click “subtract”
Photo 7
- You will have three belt pieces now you can delete the original rectangle that is on the larger diameter
  - DO NOT DELETE THE SQUARES
Photo 8
- You can move your pieces back into place
- Add text
Select all objects and make a copy off to the side
- with this copy delete the larger diameter and the smaller circles ONLY
  - Select these pieces and change the settings to cut
Make sure your larger diameter and smaller diameter are set to cut and text on the larger diameter is set to score