A look into the classroom – a thank you in book form

Buch Schule Danke.xs
Buch Schule Danke
.xs
Application scenario
Laser processing (120min)
Machine & module
xTool P2S
55W
Material used
1/8"(3mm) Basswood Plywood
Glue
Superglue
Acrylic pens
gift
64
2211

Information

      This project is a special memento for a teacher: from the outside, it looks like a large, closed wooden book. Only through the viewing window in the book cover do you discover a small classroom inside.

The body of the book was constructed of wood. The rounded spine is created by a living hinge, which creates the typical shape of a bound book. The visible front sides have been engraved with fine lines to make them look like many overlapping paper pages.

Inside there is a small classroom scene with blackboard, teacher's desk and student desks. The furniture was put together from individual, laser-cut wooden parts and glued. Small school books, notebooks and pens are engraved directly on the table tops. This creates a spatial effect without the scene being overloaded by too many sensitive individual parts.

On the board is the personal message:

"Thank you for helping us grow."

The front of the book is engraved:

"For our teacher"

The motif is complemented by an apple, books and floral decorations. The viewing window turns the book into a small stage and invites you to take a closer look.

The idea behind the project is not only to write a thank you note on a sign, but to present it as a little story. Teachers don't just impart knowledge. They accompany children, give them security, encourage them and help them to grow a little further every day.

In this way, the project combines the form of a book as a symbol of knowledge with a classroom as a place of shared memories. It is decoration, personal gift and memento at the same time.

https://www.facebook.com/michael.bauer.3517/posts/pfbid0dCbwjgjF3xSd5SEvYcubGtreaHDLTDvdcnGCzsyqEhvdv4JXRRPcaMnJADRd1dzTl

https://www.instagram.com/p/Da25Y6hDd8ZMibd0xVjTHNqJZaOBfGFHygACVE0/?img_index=10

Reddit:

https://www.reddit.com/r/xToolOfficial/s/i1cR2Lt4fi
    

Instruction

1

Step1

Quick guide

  1. Laser the front, back and living hinge from 3 mm plywood.
  2. Carefully bend the Living Hinge and glue it to the book body with the upper and lower fittings.
  3. Insert the front faces with the engraved paper structure.
  4. Laser, connect and glue the blackboard, desk and student desks separately.
  5. Engrave books, notebooks and pens directly onto furniture.
  6. Align the classroom in the cavity and glue it in place.
  7. Finally, clean all edges and paint or oil the front as desired.

https://www.reddit.com/r/xToolOfficial/s/i1cR2Lt4fi

 

Comments

Remixes