Report

[Laser cut and engrave] TV remote control holder — Project made with D1 Pro machine for Laser cut and engrave.

TV remote control holder

ID 16444

Instruction

Files

Original files

AuthorD1 Pro · 4mm MDF

Add Make Profile

Same design, different machine, material, or any improvement · Earn 100 Credits

Tips for a great Make Profile →

262

4235

Information

      Remote controls are easy to misplace and expensive to replace if broken so having a place to store and organise them can be very useful. This organiser can hold 3 remotes of different sizes and the angled design makes it easy to access even small remotes in the front section.

Instruction

Step1: Design

Preview

The design of the remote holder is simple yet functional and consists of 2 side pieces featuring remote control engraving, a bottom piece, and 4 inside pieces to divide the space into 3 sections.

Step2: Cutting settings

These are the settings used to cut 4mm MDF using the xTool D1 Pro 5w laser.

Most 4mm materials should cut with these settings but they will need to be adjusted for use with other laser machines.

Step3: Score and engrave settings

Preview

The remote outlines on the sides are scored while some of the buttons are engraved to stand out and add contrast.

Step4: Assembly

Preview

This organiser is simple to assemble and all parts should slot together tight enough not to need any glue, although glue can be used to add extra strength if needed.

Comments