Wooden storage display for magnets

Instruction

SUPPORT POUR AIMANTS 3MM

.xs

243

Information

      Display or support to store the magnets of our machines, personally they are everywhere, and can be damaged because the magnets between them are very strong, so to facilitate their use and avoid their degradation, I created this small support. Can be used on most lasers in the xTool range with your appropriate settings.
Display or holder to store the magnets from our machines, personally they are scattered everywhere and can get damaged because the magnets are very strong with each other, so to make them easier to use and prevent damage, I made this little holder. Usable on most xTool lasers with your adjusted settings.

Instruction

Step1: Instructions See Canvas 1

All the instructions on the 1st canvas, normally I thought of everything.

Only for 3mm, usable with most of the lasers in the range, whether with wood or why not in transparent acrylic it can be fun, don't forget to share by mentioning me, thank you

Karine GravKrea (workshop)

All the instructions for the first canvas, normally I thought of everything.

Only for 3mm, usable with most lasers in the range, whether with wood or why not with clear acrylic, it can be fun. Don't forget to share and mention me, thanks to you.

Karine GravKrea (workshop)

Step2: file

Instructions are on the canvas 1

Don't forget to adapt to your settings according to the materials used and your machine can be suitable for the m1 ultra by spanking on several canvases.

The file is on the 2nd canvas usable for all materials in 3mm only with most lasers in the range, the file is not editable.

If you make it in transparent acrylic I would be curious to see the final rendering, don't forget to share your finished creation by mentioning me on the networks, thank you.

I hope this file will be useful to you, to facilitate their storage, and their durability, because by putting them together they can be damaged.

The instructions are on canvas 1.

Don't forget to adjust according to your settings depending on the material used and your machine. It can work for the M1 Ultra by doing it on multiple canvases.

The file is on the 2nd canvas, usable for all 3mm materials only with most lasers in the range. The file is not editable.

If you make it in clear acrylic, I'd be curious to see the final result. Don't forget to share your finished creation and tag me on social media, thank you.

I hope this file will be useful for you, to make storage easier and increase durability, because if you put them together, they can get damaged.

Comments