Colorful bee

Information

      Engraved bee layer by layer 
insert the element you want to engrave into the laser and tape it so that it does not move, this is a very important thing

First, a black layer of engraving to create a cavity, then a black paint powder (fishing) after the paint has hardened, we return to the engraving and burn the indentation on the wings, then the powder and burn the powder, light inks react worse to the laser,
At the very end, the yellow layer is first an engraving that will make a recess for us, and then the laser curing

On the Xtool F1 laser, I have the curing of the paint set to 15% and 160mm/s 
on the xtool S1 laser 5% and speed from 100 to 160mm/s ( I am still experimenting )