Wooden moon and mountain lamp

The lamp is simple to create and put together. First, cut out the 4 sides, top, and bottom panels. I used 3mm walnut plywood. 

Once cut out, I used vellum, or mulberry paper, glued to the back of the 4 side and top panels to diffuse the light

There is a cutout on the bottom panel to allow a cord to go through it. I used an led light disk for light. That cutout will align with the panel missing some cutouts on the bottom. 

Align and glue those two panels together, making sure you have out whatever light source through the cutout first.

Do the same with the other 3 panels, and then finally the top. 

https://www.reddit.com/r/xToolOfficial/s/GyVpp4g53w

https://www.facebook.com/share/p/1Dhd5wEuaK/