Round Brass Duck Medallion – IR Laser Engraving & UV Printed Background

Use a 3 mm polished brass plate. Remove dust, fingerprints, and oil with isopropyl alcohol and a lint-free microfiber cloth. A clean surface improves engraving consistency and UV ink adhesion.

Open the project in xTool Creative Space and verify that all artwork is positioned correctly. Ensure the medal outline, character, and engraving regions are scaled as intended before starting.

Place the brass plate flat on the F2 Ultra worktable and secure it to prevent movement during engraving. Any movement can affect alignment, especially if UV printing will be applied afterward.

Run Auto Focus, then use Frame to confirm the engraving area matches the brass blank. Adjust the artwork position if necessary.

Before engraving the final piece, run a small material test on an offcut or an unused corner of the brass. Brass composition and surface finish vary between manufacturers, so use the test to confirm the desired engraving depth and appearance.

Select the IR laser module and engrave the character and border using the parameters included in the project. Monitor the first few passes to ensure the engraving is clean and consistent.

After engraving, remove any residue using isopropyl alcohol and a microfiber cloth. Ensure the engraved surface is completely clean and dry before applying UV ink.

Apply UV printing only to the background areas. Leave the engraved character, outer rim, and decorative border unprinted so the natural brass finish remains visible and provides strong contrast.

Allow the UV ink to cure completely according to your printer's process. Inspect the medal for complete ink coverage, clean engraving lines, and proper registration between the engraving and printed background.