Report

[Laser cut and engrave] Halloween Sign Glow in the Dark with XTOOL Material — Project made with xTool P2 machine for Halloween.

Halloween Sign Glow in the Dark with XTOOL Material

Instruction

If the shoe fits Halloween Sign 11 inch glow

.xcs

Application scenario

Laser (45min)

Machine & module

xTool P2

55W

Material used

1/8"(3mm) MDF Board

3mm Glow in the Dark Acrylic

3mm MDF Board

1391

Information

      This small Halloween sign glows in the dark and is made with XTOOL glow in the dark acrylic and XTOOL colored MDF material. The best thing about this project is there is nothing to PAINT! It took less than 20 minutes to to cut and about 15 minutes to assemble. I am going to hang it on my front porch so the sun can charge it during the day so it will glow at dark!

Halloween

Glow in the Dark

Instruction

Step1: Supplies Needed

Preview

1 Sheet of Light Green Glow in the Dark Acrylic 3mm

1 Sheet of Yellow Glow in the Dark Acrylic 3mm

1 Sheet Black MDF 3mm

1 Sheet Purple MDF 3mm

Glue (All Craft Multi Glue Used)

Step2: Cut Acrylic Pieces - Round Base and Witch Boot

Preview

Cut round base (approx 11") out of pale green acrylic and boot top out of yellow acrylic. (Glow in the Dark)

Step3: Cut Words and Boot Base out of Colored 3 mm MDF

Preview

Cut letters out of black MDF and your option for what color you would like boot base to be. I like purple so I used purple for the boot base but the purple only shows during the day while the sun is charging the sign for the bright glow surprise when night falls.

Step4: Glue Project Together

I tried “All Craft” multi glue for the first time on this project because I heard it does well with acrylic, is clear and does not crackle. I was pleased with the results but I could see the glue through the acrylic but it was very minimal and hardly noticeable. My favorite thing about this project was I did not have to paint anything. The XTOOL pre-colored MDF is the way to go!!!

Comments