Report
![[Laser cut and engrave] Give Thanks Napkin Holder](https://image-res.xtool.com/resource/xtool/community/attachment/xtool-community/95f219d5-04c6-4b2a-8a32-756f15e7f5e5?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
![[Laser cut and engrave] Give Thanks Napkin Holder](data:image/gif;base64,R0lGODlhAQABAAAAACH5BAEKAAEALAAAAAABAAEAAAICTAEAOw==)
Give Thanks Napkin Holder
InstructionGiveThanksNapkinHolder
.xcs
Application scenario
Laser (15min)
Machine & module
xTool M1
10WCompatibles · 12
Material used
1/8"(3mm) Basswood Plywood
3mm Basswood Plywood
25
774
Information
Spruce up your Thanksgiving table with these give thanks napkin holders
Instruction
1
Step1: The Design
Preview
Preview
Preview
- start by creating a small circle
- create another smaller circle inside of that one
- Create text for this project I used “give thanks”
- arch the text so its arching with outter circle
- to arch text click on the text and click and drag the arching symbol to the right of the text
- Once you have the text arched drag the text over the circle so it is overlapping slightly
- you might have to play with the arch again if not all the characters are overlapping.
- set both larger circle and the text and click “unite” on the right side panel
2
Step2: Laser
Preview
- Make sure all objects are set to “cut”
- Auto measure your material
3
Step3: Notes
Preview
- This can be painted, stained or left bare.
- I think I nice stain and varnish will make it look great!
- You can also double cut this to make it extra strong and glue the two pieces together.
Comments
