304 steel pendant with dancer motif in colorful clothes

Clean the pendant on both sides, with isopropyl alcohol, and dry with microfiber.
Paint a thin layer of dark paint or stick a very thin opaque adhesive on the side that will not be engraved. This step is for autofocus.
Open the XCS file, and enable infrared warm-up.
Identify the three groups of vectors to be engraved, named:

Dancer Colors
Dancer Black
Dancer Outline

By default, the output is disabled for the three groups
Use a round medallion of thickness 1 to 1.5 mm in polished 304 steel (preferably), minimum 28 x 25 mm.
Place the autofocus side under the center spot, close the cover, and autofocus
Flip the pendant over and position it horizontally, about 1 cm below the center spot. Select
all three groups simultaneously to size and place the model on the pendant.
Verify that all three groups have their output disabled
 

Activate the output of the "Dancer Colors" group, and start the engraving
The engraving lasts about 4 minutes.
Disable the exit of this group, and leave nothing

Activate the exit of the "Black Dancer" group, and start the engraving
The engraving lasts 5 minutes.
Do not touch anything until the engraving is complete.
Disable the output for this group.

Activate the exit of the "Dancer Outline" group, and start the engraving
The engraving lasts about 1 minute.
Disable the output for this group.

Using a non-abrasive paper towel and isopropyl alcohol, clean well without forcing.
The black areas are the most important, the paper towel should  be clean at the end.Dry
with microfiber to brighten the colors