Sailor Moon and Tuxedo Mask Crescent Moon Ornament

⚠️ Important:
If you change the material, the default settings included in this file will also need to be adjusted.
Using a different wood, MDF, or acrylic may result in poor or unsatisfactory results if the parameters are not recalibrated.

XCS may sometimes automatically consolidate operations.
Before running the job, verify that Engrave and Cut are still separated, and manually reassign them if needed.

1. Power ON the xTool M1 Ultra
2. Install the honeycomb bed
3. Place the wood sheet on the honeycomb
4. Secure material using magnets, ensuring flatness

1. Open xTool Creative Space (XCS)
2. Import the bookmark file
3. Position the design within the material area
4. Perform Auto Focus
5. Use Frame to confirm alignment

Acceptance Criteria

Engraving is clear and legible
Consistent engraving depth
No excessive burn marks
Clean cut-through edges
Dimensions per design

FINISHING (IF APPLICABLE)

Light edge sanding (grit 220–320)

Clean engraving residue

Optional sealing or oil finish

STORAGE

Store keychain flat

Protect from moisture and bending

Avoid stacking without separators