Report

[Laser cut and engrave] Фигурка Барта Симпсона со скейтбордом — Project made with F2 Ultra machine for Laser cut and engrave.

Coloured 301 stainless steel engraving machine F2 Ultra (IK-MORA)

Instruction

Bart Simson color F2 Ultra IK-MORA

.xcs

Application scenario

Laser processing (16min)

Machine & module

xTool F2 Ultra

40W, 60W

Compatible xTool Machine

F2 Ultra UV

F2 Ultra（Single）

Material used

Stainless Steel 301

1073

Information

      I test the machine on various materials and decided to make a colored stainless steel engraving. But unfortunately I did not find 304 and this is a test project for 301 stainless steel. The difficulty is that the colors from the test grid did not match the colors in the picture when engraving.

Bart

F2 Ultra

Engraving

Instruction

Step1: TEST!

Preview

As I saw earlier, on any new blank from any stainless steel, we first make a test mesh. I found it on this site and just repeated.

Step2: Creating a layout

Preview

I downloaded the picture from the Internet, then the AI merged the colors for me and removed the background. Next, I made a trace in Corel Draw and combined the colors again, after which I combined them.

Step3: Selection of engraving parameters

Well, then select colors from the test table and try to engrave. And so on until the desired result comes out. It was important for me to choose yellow. The first attempt - Bart's skin was purple. With the second I got the result. But I lost the red color of the T-shirt) Experiment and share the result.

Comments