applemanormercantile

Self-adhesive Vinyl Silver Starlight Brushed

Setting for Die Cut part of Print & Cut sticker Generator

MachineM2(Blue light · 10W)

Processing ModeMulti-module processing

Processing typeCut

Thickness0.25mm

Material colorWhite

Brand/SupplierxTool

Settings

Precautions

Wear goggles that match the wavelength of the light source

When operating with open covers or using open-type devices, be sure to wear laser goggles that match the wavelength of the light source. Different light sources (blue light/infrared/CO2/UV) have different wavelengths; please pay attention to whether the wavelength protected by the goggles matches the laser;

After processing is complete, wait until the smoke is cleared before opening the lid to retrieve the part

After processing, do not open the lid immediately. Wait for the smoke exhaust system to run for 10~30 seconds and after the smoke inside the chamber is completely removed before removing the part. Opening the lid immediately will allow unvented smoke or odorous gases to flow directly into the operator's face. Ensure good ventilation and wear a protective mask if necessary.

Did these settings work?1 makers tried these settings

1worked

0didn't work

Self-adhesive Vinyl Silver Starlight Brushed

Similar Materials