K5 Crystal Keychain
k9 heart crystal 3d mesh point cloud using lasertools.ai and there prefer settings and it comes out great settings power 55 dots 200 layer height 0.04 khz 60
MachineF2 Ultra UV(Ultraviolet light · 5W)
Processing ModeInner Engraving
Processing type3D Inner Engraving
Thickness11.5mm
Brand/Supplierk9 hearts
SettingsPass1
Speed80mm/s
Power55%
Dot duration200s
Frequency60kHz
Layer Height0.04mm
Engraving MethodDotting
refractive_index1.5
Pass1
Speed80mm/s
Power55%
Dot duration200s
Frequency60kHz
Layer Height0.04mm
Engraving MethodDotting
refractive_index1.5
Version: 2.0.0
0
Precautions
Wear goggles that match the wavelength of the light sourceWhen operating with open covers or using open-type devices, be sure to wear laser goggles that match the wavelength of the light source. Different light sources (blue light/infrared/CO2/UV) have different wavelengths; please pay attention to whether the wavelength protected by the goggles matches the laser;
Prevent high-temperature burns after processingFreshly processed materials and cuts are very hot; please wait for cooling or wear gloves to pick up parts; do not touch them directly.
🔔 Processing Tips
Clean the surface before marking
spray rubbing alcohol 70% i use and use a mirco fiber clothes and make sure you wear a rubber glove on the hand you are holding it in so after you clean it you dont put finger markers on it
Did these settings work?No results yet
No one has shared a result yet. Be the first to let other makers know if these settings worked.