Josh
Josh

Stone

MachineS1(Blue light · 20W)
Processing ModeCurved material
Processing typeEngrave
Settings
Pass1
Speed20mm/s
Power100%
Spacing150°
Engraving modeBi-directional
Laser typeBlue light
Version: 2.0.0
Parameter ConverterLimited-time Free
Convert to My Machine Parameters
13
Precautions
Wear goggles that match the wavelength of the light sourceWear goggles that match the wavelength of the light source
When operating with open covers or using open-type devices, be sure to wear laser goggles that match the wavelength of the light source. Different light sources (blue light/infrared/CO2/UV) have different wavelengths; please pay attention to whether the wavelength protected by the goggles matches the laser;
After processing is complete, wait until the smoke is cleared before opening the lid to retrieve the partAfter processing is complete, wait until the smoke is cleared before opening the lid to retrieve the part
After processing, do not open the lid immediately. Wait for the smoke exhaust system to run for 10~30 seconds and after the smoke inside the chamber is completely removed before removing the part. Opening the lid immediately will allow unvented smoke or odorous gases to flow directly into the operator's face. Ensure good ventilation and wear a protective mask if necessary.
Did these settings work?No results yet
No one has shared a result yet. Be the first to let other makers know if these settings worked.