Chipboard
I used a brown 1.9 mm Chipboard for bookbinding on an M2 Laser with a 20 W module to cut the chipboard in 1 pass. I used the 4 little magnetic feet to lift it out of the baseplate. The edges were a little charred, so I just cleaned them with a paper towel.
MachineM2(Blue light · 20W)
Processing ModeProcess on baseplate
Processing typeCut
Thickness1.9mm
Material colorBrown
SettingsPass1
Speed12mm/s
Power75%
Number of tabs2
Tab spacing100mm
Generateby number
Tab size0.5mm
Airflow of air pump100%
Min Output Power15%
Focus descent distance1mm
Focus descent per step1mm
Initial focus descent distance1mm
Descent interval (descent every N layers)1
sinkingMethodone
Power control modeFOLLOW_ACTUALLY_POWER
Pass1
Speed12mm/s
Power75%
Number of tabs2
Tab spacing100mm
Generateby number
Tab size0.5mm
Airflow of air pump100%
Min Output Power15%
Focus descent distance1mm
Focus descent per step1mm
Initial focus descent distance1mm
Descent interval (descent every N layers)1
sinkingMethodone
Power control modeFOLLOW_ACTUALLY_POWER
Version: 2.0.0
Parameter ConverterLimited-time Free
Convert to My Machine Parameters7
Did these settings work?No results yet
No one has shared a result yet. Be the first to let other makers know if these settings worked.