Wine Barrel and stand

Cut your parts out and organize by piece.

Start with the open side and start putting the holder pieces in place. This is not fun..  takes a while to assemble, and the last piece is difficult to get in place.

Get some good rubber bands!  

Line up the small square hole to the opposite side of the coin slot.

Wrap the barrel staves with the rubber bands and place the tap end in the holes.

Two hands required for this!

Squeeze the barrel ring onto the end.  Fit the staves into the ring and slide the ring up past the holes.

Add barrel pegs around the tap end ring.  This can be done without glue but I glued this one.

Once the pegs are in remove rubber bands.

Glue that tap in place and carefully put the tap handle on. It doesn't need glue so it can move.

Glue the stand together and put the rings on the ends.

Glue the coin plug together. 

Let it dry

Insert it in the end and twist into position.

Congrats! you're done!