Holder for an 'electric tealight'

ID 80867
Instruction
Files
Original files
AuthorS1 · 1/8"(3mm) Walnut Plywood
1
Preview
Add Make Profile
Same design, different machine, material, or any improvement · Earn 50 Credits
Tips for a great Make Profile →
gift
34
1617

Information

      This holder is easy to built and you can hang the lights instead of putting them on a flat surface. The holder has a hole at the top and bottom to be able to 'chain' multiple holders. I use them with a remote control. It creates nice possibilities for soft lighting, and of course you can hang them in an Xmas tree, or in front of a window.
    

Instruction

1

Step1: Cut out the parts and glue the top and bottom ring as shown in the picture

Holder for an 'electric tealight' instruction: step 1 - Cut out the parts and glue the top and bottom ring as shown in the picture
Preview
Holder for an 'electric tealight' instruction: step 1 - Cut out the parts and glue the top and bottom ring as shown in the picture
Preview

The project file is meant for 3mm plywood. The setting which I use for a 40W xTool S1 is:
Speed: 12 mm/s
Power: 80 %

2

Step2: Add the other 4 parts, glue is not needed, click them in the 2 rings

Holder for an 'electric tealight' instruction: step 2 - Add the other 4 parts, glue is not needed, click them in the 2 rings
Preview
Comments

Remixes