Rectangle keyring Jig

ID 8009

Instruction

Files

Original files

AuthorM1 · 1/8"(3mm) Basswood Plywood, Chartreuse Stainless Steel Tumbler with Handle (24oz)

Add Make Profile

Same design, different machine, material, or any improvement · Earn 100 Credits

Tips for a great Make Profile →

562

3971

Information

      I was needing to engrave some keyring for my business, so I measured them and kept playing with the sizes after cutting a few out I eventually got to the correct size.
I cut an A4 sheet out 14 keyrings then I stuck a plain sheet of basswood behind.

Instruction

Step1

I measured my keyring which was 5cm high by 3cm wide.

I put a rectangle from shapes into xcs to that size, then I added a small circle for the bobbly bit then a larger circle for split ring.
I played around a few times then combined the shapes together.

I cut out a few shapes resizing in between and this one worked.

So I added 14 of them to an a4 sheet size and cut on my M1 10W power 100 speed 5 pass 1 on triangular prisms basswood 3mm setting.

Comments