boucles d'oreilles interchangeables (pampilles) printanières en bois

Choose your flower, in Xtool Studio, put it on your canvas, adjust it to the size you want (not too big, but not too small either), think carefully about the central hole and the size of the ring in which you are going to insert your earring, the smaller they are, the smaller the hole will be, So very thin ring, the bigger they are, the thicker you can put on rings, but be careful that it's not too big, so that it doesn't bother you at the level of your earlobes.

Select your flower and make an offset, choose your offset according to your desires, if you want thin edges, make an offset of 1  (which I did), if you want medium edges, make an offset of 2 or if you want thicker make your offset.

Important, make your offset, once the size of the earring has been chosen, because if you make your offset before and change the size later, you could have errors (offset size not correct, offset shifting,.....).

The red part will be cut out and the green part will be engraved.

Once everything is perfect, select and duplicate your image (copy/paste), to have the earring pair

You 

can do the deep engraving, front and back, but remember not to make the first cut from the center (create another color for the central hole and put it in the center, this will prevent you from engraving your device).

Once you enter the settings, launch your device, the larger the loop, the longer it will take and if you do both sides, you double your time even more.

Once finished, all you have to do is treat your pair of earrings, put them on and you're ready to go out. 

Please send me pictures of your achievements and feel free to ask me any questions, if you have any.