Thank you glasses with 3 different patterns

clamp the glass in the Rotory with the open side of the glass on the motor side. Do not clamp the Rotory too hard, as the glass may break. 
On the back, place the clamp (see photo 1)

Make sure the rottory is aligned so that the red dot for the distance measurement is at the highest point of the long drink glass.

And always and every time when changing the glass, let the machine determine its height. After all, each glass often has different values.

Ready?

1. Check for the last time, if the tissue on the glass still feels moist/wet. 
   If this is not the case, you can sprinkle it again with water in the Rottery while the glass is in the Rottory.. en push start button

-→ Watch out! electrical parts of the Rottory, can NOT withstand water. So only moisten the tissue and not

1. Remove the glass from the machine and gently wipe the issue off the glass.
2. With washing water and another tissue you can remove the remains of the "ravished" tissue from the glass.

1. As a final step, you can carefully dry the glass again. 
   1. Why carefully: By engraving glass, you actually damage the glass and there may still be small burrs on the surface. You can remove them from the surface in a calm and controlled manner.

1. When the glass is dry, you will see that the engraving becomes whiter and therefore clearer. 

Your glasses are ready. Have fun with the execution

For the other tree glasses it is the same procedure

Thanks for downloading❤️this project and have more fun with our (other) models.😍

It is always fun to make it, and also nice to 🎁 it away afterwards.

Happy with this project? Give me a 👍up. THKS.