Wedding Ring Box

• Start out about inserting a heart from the left side panel under basic shapes
  • Dimensions used 5.3" x 4.8"
• Create an offset distance of the heart .16"
• Also make a internal offset disant of the heart.
• That the largest heart and create a copy
  • You will have two copies of the larger heart.
• Now the two other hearts we will group together.
  • Select them both, right click and “group”
• Now right click again, copy and paste it three more times
  • You have four heart outlines and two large hearts
• One of the four outlines right click and ungroup it.
  • Delete the outer heart.
  • Make an offset of the heart of 0.159
  • Delete the smaller heart
  • Select both hearts left 
    • right click and “group”
• Now had some text to the one of the biggest hearts. (This will be the top of the box)
  • I used bride and groom, but you can certainly use the names of the actual bride and group and the date they are getting married.
• Prep for laser, make sure everything but the text is set to “cut” and the text is set to engrave. 
• Dont forget to automeasure you material!

• To help with this part, each section is seperated on different canvas in XCS.
  • Canvas 1: is the top and bottom of the box.
    • The small hearts will be glues where the scored hearts on the base of the box,
  • Canvas 2: is the middle sections.
    • All these pieces will be glued together and then glued to the base.
  • Canvas 3: is the outline that will be glued to the back of the top of the box.
• When glueing all of the pieces together make sure everything is flush together.

After all the glue has dried you can chose to stain if you like.

There it is! The box is complete for your house your beautiful rings!