Report

[Laser cut and engrave] Laser Cut Wooden Tree of Life Memorial Plaque with Heart Engraving — Project made with F2 Ultra UV machine for Laser cut and engrave.

Memorial: Tree of Life

Instruction

Memorial_TreeOfLife

.xcs

Show 2 more

Application scenario

Laser processing (53min)

Machine & module

xTool F2 Ultra UV

Compatible xTool Machine

F2 Ultra（Single）

F2 Ultra

F1 Ultra

F1 Lite

P2S

M1 Ultra

D1 Pro 2.0

D1 Pro

Laserbox

Material used

1/8"(3mm) Walnut Plywood

167

1879

Information

      •	I recently had a last-minute request for a "tree of life" memorial to honor a deceased family member and felt horrible I had nothing in stock to personalize at the last minute.
•	Here is my version of what I could have offered and will keep for last minute customization so I can be better prepared in the future should someone need a last-minute memorial that can be personalized
•	Credit to @sharonstreetstudios

Instruction

Step1: Memorial: Tree of Lif

Created Tree of Life using Atomm’s AI Make (https://www.atomm.com/aimake) by asking for a vector based on tree of life to use for a cut laser file. I downloaded the png for later use, then opened directly into Xtool Studios. I added a box to the bottom of the vector to add a sentiment and a place for “customizing” along with a small stand. I used my F2 Ultra UV and 3mm walnut wood to cut and engrave using the following settings. Project took 53 minutes run time on laser. I did run engraving separately so I could use washi tape and fill engraving with colors. Polycrylic used over entire memorial.

Comments