Report

[Laser cut and engrave] Barstool Customization — Project made with P2 machine for Laser cut and engrave.

Barstool Customization

Instruction

Files

Original files

AuthorP2 · Wooden Barstool

Add Make Profile

Same design, different machine, material, or any improvement · Earn 100 Credits

1829

Information

      If you want a fun way to showcase your laser cutter, place names or logos on your barstools, etc. this can be a run way to put it to the test!

I work at a school, and used this to assign placements to the 8th graders who run our tech booth for events.

Instruction

Step1: Engrave into top of Barstool

Preview

Settings here really depend on what you want to put on your barstool. Depending on your logo, or whatever you decide to put there other than text. It's better to start with a lower power setting and enhance it if you need to, than to go too deep.

Step2: Clean Up

Preview

After you're done, you should clean the engraved area with white vinegar on a soft sponge. Remove all of the ‘burn’ runoff and anything left behind by the laser cutter. Then attach to your stool base and you're done!

Comments