Lyuba

รายงาน

[Laser cut and engrave] Easter Basket — Project made with xTool M1 machine for Laser cut and engrave.

Easter Basket

คำแนะนำ

EasterBasket

.xcs

สถานการณ์การใช้งาน

เลเซอร์ (15min)

เครื่องจักรและโมดูล

xTool M1

10W

วัสดุที่ใช้

Book Board and card stock

book board

cardstock

893

ข้อมูล

      I made this to fit on a narrow ledge but still look like an Easter Basket.  I cut it out of "Book Board" I found on Amazon.  I based it on a basket I made with a Cricut several years ago.

คำแนะนำ

ขั้นตอน1: Cut out the basket parts from book board or other material of choice

Cut the pieces of the basket out of sturdy material.

ขั้นตอน2: Cut grass from green cardstock

Cut the grass out of green cardstock. Alternatively you could use store bought easter grass.

ขั้นตอน3: Glue the two bottom pieces together centering the smaller on the larger. The smaller piece is there to square the sides.

Glue the two pieces of the bottom together. The larger piece is the part that actually sits on the shelf, the smaller piece is to line up the front, back and sides and give the glue something to stick to.

ขั้นตอน4: Put a line of glue all the way around the perimeter of the smaller bottom piece.

Put a line of glue all the way around the outside of the smaller piece of the bottom.

ขั้นตอน5: Set up the front and back in the glue.

Set up the front and the back in the line of glue. You may need a second set of hands.

ขั้นตอน6: Put in the sides

Put a line of glue on the sides of each of the side pieces and slide them into place. Notice that the sides are not flush with the front and the back, they are slightly indented.

ความคิดเห็น