Eagle Head Relief Engrave

Instruction

Eagle Head Relief Engraving

.xcs

Application scenario

Laser (90min)

Machine & module

xTool S1

40W

Material used

Maple Hardwood

1476

9696

Information

      This is another relief project that finished up on my S1 40 Watt Laser.

30creatorschallenge

Eagle

relief

Instruction

Step1: Select your Wood

Preview

Select a clean piece of 6" by 6" maple (or other hardwood). Sand the surface with progressively finer grits of sandpaper until smooth.

Step2: Load the File and Set Up for Engraving

Place the 6" by 6" maple into the laser. Adjust your focus and set the engraving area.

Make any necessary adjustments based on the power of your laser. The settings for this project were created for the S1 40 watt laser.

Step3: Finishing up!

Preview

Once engraving is complete, carefully remove the piece from your laser. Inspect the engraving for any rough edges or imperfections. Lightly sand the engraved areas if needed, taking care not to damage the design.

Choose a suitable clear wood finish to enhance the natural beauty of the maple and protect the engraving. Apply the finish evenly across the surface, following the manufacturer's instructions.
Allow the finish to dry completely, applying additional coats if desired for a richer appearance.

Enjoy your “Eagle Head Relief Engrave” relief engraving!

Comments