![[Laser cut and engrave] Laser Cut Wooden TIE Defender Starship Model Display](https://storage-us.atomm.com/resource/xtool/community/attachment/xtool-community/730e6f1c-83cf-4318-a188-0646887f5ca1.jpg?x-oss-process=image/resize,w_1200,h_900,limit_0/interlace,1/format,webp/auto-orient,1)
Star Wars Mini Tie Defender
Instruction
Information
I made this based on the Tie Interceptor.
This is the only place on the internet that you will find this model!
Instruction
Step1: Cut and layout the pieces as shown
Lay out all pieces after cutting
Step2: Build front
Take the narrow disc stabilizer piece and glue it in place.
Add disks from the right to left in the picture above. It makes a ball shaped piece.
add mid wing holders. Gather the ones that all have the tab towards the top.
Step3: Back side
Glue the disk holder in place.
Add two of the same sized larger disks first, then the smaller one.
Glue the wing attachment pieces on.
Step4: Wings
Glue the wing pieces in place. The mid section piece was easier to put on starting with the hole in the rear (lined section) first, then tipping the wing into the other tabs.
Carefully add the two other wing pieces on.
Do the same for the other two wing sets.
Step5: Build the stand
Glue pieces together as shown in the pictures
The two small H pieces have a short side. That faces the rear of the stand.
I'll make some improvements to the stand.
*** To place the Defender on it's stand you'll need to tip the ship at an angle and place it through from the back of the ship.
Step6: Finish up
All Done!
Have fun! This is #10 of 10 Mini Star wars fighters.
I hope to have more soon!
