"MOM" heart & flower stand

Instruction
momstand.xcs
momstand
.xcs
Application scenario
Laser (60min)
Machine & module
xTool M1
Compatible xTool Machine
P3
F2
F2 Ultra UV
F2 Ultra(Single)
F2 Ultra
F1 Ultra
F1
F1 Lite
S1
P2S
P2
M1 Ultra
D1 Pro 2.0
D1 Pro
D1
Laserbox
M2
Material used
1/8"(3mm) Basswood Plywood
gift
70
2343

Information

      I wanted to make a cute MOM stand that shows the appreciation for the unconditional love of mothers. I used kraftpaper, paint, glue, and basswood. I have been enjoying doing the kraftpaper overlay for design as it adds a lot of decoration to the design without having to pain it. It's a simple way to add that magic touch and the M1 cuts the paper flawlessly.
    

Instruction

1

Step1: Download the file and place material into machine.

"MOM" heart & flower stand instruction: step 1 - Download the file and place material into machine.
Preview

Download the “momstand” XCS file and open in XCS. Place your chosen material into the machine. This design is made for 3 mm material. Alterations will need to be made if choosing another thickness. 

2

Step2: Cut out your file

"MOM" heart & flower stand instruction: step 2 - Cut out your file
Preview
"MOM" heart & flower stand instruction: step 2 - Cut out your file
Preview

Cut out your file. I also chose to cut out the “mom” and the smaller hearts with Kraftpaper to add an extra element to the design. 

3

Step3: Paint your pieces and glue Kraft paper as desired.

"MOM" heart & flower stand instruction: step 3 - Paint your pieces and glue Kraft paper as desired.
Preview
"MOM" heart & flower stand instruction: step 3 - Paint your pieces and glue Kraft paper as desired.
Preview

Paint and glue as desired. I use double sided Kraft paper so I can just swap sides for a different design. 

4

Step4: Put all the pieces together.

"MOM" heart & flower stand instruction: step 4 - Put all the pieces together.
Preview
"MOM" heart & flower stand instruction: step 4 - Put all the pieces together.
Preview

Place all your pieces together. Some of the slots were a little loose so I decided to cut out and extra layer on the bottom so the pieces stood up straight. You can choose to tighten the slots or cut out the extra bottom piece to help the pieces stand up straight. 

Comments

Remixes