chris.holtzem

Bericht

[Laser cut and engrave] Barstool Customization — Project made with xTool P2 machine for Laser cut and engrave.

Barstool Customization

Anleitung

Barstool

.xcs

Anwendungsszenario

Laser (20min)

Maschine & Modul

xTool P2

55W

Verwendetes Material

Wooden Barstool

773

Information

      If you want a fun way to showcase your laser cutter, place names or logos on your barstools, etc. this can be a run way to put it to the test!

I work at a school, and used this to assign placements to the 8th graders who run our tech booth for events.

Anleitung

Schritt1: Engrave into top of Barstool

Barstool Customization instruction: step 1 - Engrave into top of Barstool

Vorschau

Settings here really depend on what you want to put on your barstool. Depending on your logo, or whatever you decide to put there other than text. It's better to start with a lower power setting and enhance it if you need to, than to go too deep.

Schritt2: Clean Up

Barstool Customization instruction: step 2 - Clean Up

Vorschau

After you're done, you should clean the engraved area with white vinegar on a soft sponge. Remove all of the ‘burn’ runoff and anything left behind by the laser cutter. Then attach to your stool base and you're done!

Kommentare