Round Slate Plaque Featuring Outdoorsman Hunter and Angler Imagery

First, I cleaned a 4" x 4" slate coaster with isopropyl alcohol to remove any dust, oils, or residue. I then applied a clear sealant and allowed it to dry and cure for approximately 20 minutes.

Once fully dry, I placed the coaster on the xTool F2 Ultra MOPA and selected the appropriate material settings in xTool Studio. After framing the design and confirming placement, I engraved the coaster using the settings provided below.

For best results, ensure the slate surface is clean, level, and completely dry before engraving. Follow the included settings for each coaster design.