Easter wall hanger

Instruction

Files

Original files

AuthorP2 · 1/8"(3mm) Basswood Plywood, Chartreuse Stainless Steel Tumbler with Handle (24oz)

Add Make Profile

Same design, different machine, material, or any improvement · Earn 100 Credits

1866

Information

      You can hang this Easter hanger on a hook on your wall. But you can also reduce these and hang them in the Easter branch. Enlarge or reduce this pendant at your own discretion. Make sure you group the design as a whole and then make it smaller.The images were created with AI and adapted to the design.

BeIn30Creators

Instruction

Step1: Cut and engrave the parts of the Easter Wall Hanger

Preview

In the XCS file, the parts are grouped so that you can reduce or enlarge them as a whole. At your own discretion.

Step2: Assemble the Easter Wall Hanger

Preview

4 More images

Take about 1 meter of rope. Make a very thin piece of tape on both sides of the rope to make a sharp point. Take the egg labeled "Happy" and thread the string through the hole of the egg. Take the bead and thread both ends of the rope through it. Slide the bead towards the "happy" egg.
Now take the 2nd bead and pass both parts of the rope through the bead. Slide the bead down and this determines the length of the "happy" egg. Insert the ends of the rope through the hole in the main hanger. Thread the ends of the rope through the 2nd bead again (there are now 4 wires through it). Slide the 2nd bead to the hole of the main pendant. Make the string for the "easter" egg longer than the "happy" egg.
Now take the 3rd bead and put both ends of the rope through the 3rd bead. Then both ends of the rope through the hole in the "easter" egg. Both ends now go back into the 3rd bead. Then make a knot in the rope and pull it tight. Cut off the excess rope near the knot. Then turn the bead slightly upwards for a moment so that the knot is not visible.

Comments