Easter Basket

1. Prepare the Laser Cutter:

• Load the 4mm Maple Plywood into your laser cutter.
• Open the design file in Creative Space Software and ensure the layout fits within the material boundaries.
• Secure the plywood to the laser bed to prevent movement during cutting.
• Swap the tray to the honeycomb tray or add raiser under the 3mm Plywood
• (Optional) Use some tape to hold down the board if needed. 
• Enable the output 

2. Set Cutting Parameters:

• Adjust the laser focus height and define the cutting boundaries according to your material and machine specifications.
• Double-check settings to ensure clean cuts.

3. Run the File:

• Begin the cutting process. 
• Monitor the process to ensure accuracy.

Glue the three long but thin parts in the file Easter Basket flush together and let it dry well. 

Glue the frame of the basket to one of the ornament parts. 

Repeat this for the second frame. 

Pay attention to the alignment of part A and B! (marked in the file) 

• The frame is glued on top of the ornament! Aligne both parts with the cutouts. 

Glue all together and let it dry well. 

1. First, glue the two narrow side panels to the previously assembled frames.
2. Carefully glue the bottom plate into the designated slots in the frame.
3. Now, attach the second frame to the bottom plate and the side panels. Make sure everything is properly aligned.

Let it dry well, and you're done. Now Easter can come! =D