Llavero pieza

The design is very simple to make as it consists of only two shapes, a heart and a puzzle piece. 

Create a heart of the right size to make it a keychain, it measures about 5-6 cm and the size is suitable. Then I inserted a puzzle piece shape inside the heart, this one is about 3 cm approximately. I wrote my partner's name inside, choose a font you like, I used "Amita", 

then I wrote a text inside the heart using the same font and size. 

Finally I inserted two circles of 2 mm each to be able to insert the ring of the keychain. 

We start the Xtool and check the pieces that have to be cut (the heart, the puzzle piece and the two circles) and check that the text is going to be recorded. 

We turn on the machine, put the material in and let it work. 

In a few minutes we will have the two pieces. 

Once we have our pieces, what I did was to pour a little matte varnish on both of them. I let it dry. 

Finally we put the washers and rings to form the keychains, I bought them on Amazon. 

We have a romantic keychain ready to take as a couple. 

Hope you like it!